Manual Type Noodle Making Machine
Application:This machine is used to make noodles.
Raw Material:flour
Capacity:200Sets/Per Month
Loading Porting:Shanghai Port/Qingdao Port
Voltage:50Hz/220-380v
Manual Small Noodle Making Machine is suitable for making noodles at home. This article shows some information about this noodle machine;
1) Mixing Flour: Add warm water into flour (about 2:5), can put suitable amount salt, alkali;
2） To reconcile good dough into pieces (about 20 mm), sprinkle dry flour.
3） Before using, should check the work surface, clean the dirt, and add some oil in the surface of the knife sleeve and the gear.
4） Rolling noodle: First remove the dough scraper, regulating the regulator in noodle roller to 2.5-3mm, plug in 220V power supply, press switch on the machine, put the mixed dough into the bucket, repeated pressing for 4-5 times,. At last, adjust the noodle roller to 1.5mm and re-pressing for one time.
5）Cutting noodle: Install noodle cutting knife, according to need adjustment section knife regulator
6）End: after use, turn off the machine, pull off the plug, clean the body, the knife, and roll.
Note:
1. The voltage must be consistent with the requirements
2. When the load is running, the minor section can’t be adjusted.
3. When the minor section box starts to change, it needs to be converted to the place.
4. During operation, should avoid contact between hands with the knife and roller, so as to avoid danger, and to pay special attention to avoid children's operation.
5. The machine is equipped with a thermal protection device, when the continuous working time is too long to make the motor overheat, the heat protector action to stop the machine, the power should be cut off.
1) Mixing Flour: Add warm water into flour (about 2:5), can put suitable amount salt, alkali;
2） To reconcile good dough into pieces (about 20 mm), sprinkle dry flour.
3） Before using, should check the work surface, clean the dirt, and add some oil in the surface of the knife sleeve and the gear.
4） Rolling noodle: First remove the dough scraper, regulating the regulator in noodle roller to 2.5-3mm, plug in 220V power supply, press switch on the machine, put the mixed dough into the bucket, repeated pressing for 4-5 times,. At last, adjust the noodle roller to 1.5mm and re-pressing for one time.
5）Cutting noodle: Install noodle cutting knife, according to need adjustment section knife regulator
6）End: after use, turn off the machine, pull off the plug, clean the body, the knife, and roll.
Note:
1. The voltage must be consistent with the requirements
2. When the load is running, the minor section can’t be adjusted.
3. When the minor section box starts to change, it needs to be converted to the place.
4. During operation, should avoid contact between hands with the knife and roller, so as to avoid danger, and to pay special attention to avoid children's operation.
5. The machine is equipped with a thermal protection device, when the continuous working time is too long to make the motor overheat, the heat protector action to stop the machine, the power should be cut off.
Product Catalog
Contact Us
Email:wendy@machinehall.com
Skype:wendymachinehall
Whatsapp:0086-18539931566
Tel:0086-18539931566
ADD:No.1-130 9A Area Hardware Electrical And Mechanical Market South China City Longhu Town Zhengzhou Henan Province.